Frequently Asked Questions and Solutions for Wismec Vape Mod
Today I will share with you the common problems and solutions of wismec vape mod.
A: Please make sure that your resistance is lower than 1.0ohm, otherwise the device will detect itself and will be allowed be used only in VW mode.
You could also try to take out the atomizer and switch to TC mode in room temperature.
A: Please let the device cool down for a while.
The higher wattage is, the bigger current will be, then the higher temperature will be, so it will cause more heat.
And you can try to use TCR mode and set the TCR value according to your coil's material.
Material TCR value range
Nickel 600-700
NiFe 300-400
Titanium 300-400
SS(303,304,316,317) 80-200
Our default setting is SS316, TCR value is 120.
If the value is not correct, the device will detect itself and give a wrong judgment and output.
A: For the imbalanced message, it means the voltage among your 3 batteries are not imbalance. The difference is higher than 0.3V.
Please check your batteries again.
We suggest you to change another 3 high-rate batteries with same parameter.
A: Please try as below:
1. take out the batteries
2. Open the software in the computer
3. Plug on the USB to connect computer
A: We suggest you to change another set of batteries first. It is recommended to use high-rate batteries.
Besides, pls. try to take out the batteries and tighten up the screw in the following picture:
Q: Why the device always go back to the VW mode from TC mode automatically?
A: Please make sure that your resistance is lower than 1.0ohm, otherwise the device will detect itself and will be allowed be used only in VW mode.
You could also try to take out the atomizer and switch to TC mode in room temperature.
Q: Why the device always show "Device too hot" when I press the fire button?
A: Please let the device cool down for a while.
The higher wattage is, the bigger current will be, then the higher temperature will be, so it will cause more heat.
And you can try to use TCR mode and set the TCR value according to your coil's material.
Material TCR value range
Nickel 600-700
NiFe 300-400
Titanium 300-400
SS(303,304,316,317) 80-200
Our default setting is SS316, TCR value is 120.
If the value is not correct, the device will detect itself and give a wrong judgment and output.
Q: Why the device always show "imbalanced" ?
A: For the imbalanced message, it means the voltage among your 3 batteries are not imbalance. The difference is higher than 0.3V.
Please check your batteries again.
We suggest you to change another 3 high-rate batteries with same parameter.
Q: What if the device cannot turn on after charging?
A: Please try as below:
1. take out the batteries
2. Open the software in the computer
3. Plug on the USB to connect computer
Q: What if the device always show "Check Battery"/"Low Battery"/"Weak Battery"?
A: We suggest you to change another set of batteries first. It is recommended to use high-rate batteries.
Besides, pls. try to take out the batteries and tighten up the screw in the following picture:
No comments