IJOY CAPO 100W Mod Settings - Vape Instruction

General Functions 

Enter Into The Main Menu
Press the fire button 3 times to enter into the main menu. Press the right and left regulatory buttons to switch among different functions. Press the fire button to confirm.

Power Mode 

In the main menu, switch to "P" setting, press fire button to confirm. Press right and left buttons to adjust the wattage.
Intensity Setting In Power Mode
In the main menu, switch to intensity setting, press fire button to confirm Press right and left buttons to switch among below4 modes. In user mode, press fire button to switch among each setting columns. Press right and left buttons to adjust the wattage After setup is completed, press fire button to switch to"EXIT". Press right or left button to confirm.

Norm Mode: Maintains the currently set power.
Hard Mode: 30% higher than the currently set power.
Soft Mode: 20% lower than the currently set power.
User Mode. Customize the power output for the first three seconds of each puff, with each setting column representing half a second.

Temp Mode 

Ni/ Ti /55/M 1 /M2
In the main menu, switch to”T" setting, press fire button to confirm. Press right and left buttons to switch among Ni/Ti/SS/Ml/M2 modes. Press fire button to confirm. Press right button, when "W" flashing, press right and left buttons to adjust wattage. Press left button, when"°F" or"0C"flashing, press right and left buttons to adjust temperature value.

The temperature unit will cycle between ° F and °C when the minimum or maximum temperature is reached.

In the temperature control mode to replace the heating wire, when the new heating wire resistance and the previous heating wire resistance difference greater than or equal to 0.2ohm, the screen appears the following tips. Press + to choose and confirm new coil. Press - to choose and confirm same coil.